Bag Filter Installation

During installation, please follow the steps below:
1. Place the bag filter on the workstation to be filtered, connect the inlet and outlet flanges or pipe teeth, and fix them; block the exhaust port, or configure an exhaust valve. Jacket type connects to the heat source for insulation.
2. Gently place the metal inner net into the bag filter so that the inner net collar matches the bag filter mouth.
3. Place the filter bag so that the filter bag ring and the metal inner net collar match.
4. Place the O-shaped sealing ring into the O-shaped groove. The O-shaped sealing ring cannot be twisted or deformed. The multi-bag filter buckles the filter bag pressure ring.
5. Hold the handle of the upper cover with one hand and the other end of the upper cover with the other hand (the multi-bag filter turns the top handwheel)
6. After the upper cover is aligned, tighten the two diagonal hanging caps at the same time, and tighten all the hanging caps one by one (insert a short stick into the hanging ring and tighten it).
7. Close the exhaust valve installed on the top of the bag filter.
8. Please check whether the connecting pipes are firm and whether the working pressure is within the allowable range.
9. Open the output valve. Open the heat source inlet valve to raise the filter temperature to the specified temperature.
10. Slowly open the input valve to allow the liquid to flow into and fill the filter slowly to prevent the liquid from suddenly impacting the filter bag and causing rupture, and then observe whether there is any leakage. If there is no leakage, you can start filtering.